Categories

Sharp GP2Y0D810Z0F Dalmierz cyfrowy 10cm

Adjustable, digital distance sensor with a cable length of 50 cm and nuts to facilitate mounting. Measurement range from 3 to 50 cm, is configured using a controller. Voltage supply 5 V.

More details

MOD-01825

Add to cart

Price 26,90 zł

 

Attention!

Product replaced by the new version:

Adjustable, digital distance sensor E18-D80NK 3-80 cm

 

Specification

  • Supply voltage: 5 V
  • Quiescent current: below 100 mA
  • Measuring range adjustable: from 3 to 50 cm
  • Regulator range potentiometer single
  • Output signal: digital (low as in the case of object detection, otherwise high)
  • The led, indicating the detection of the object
  • Response time: 2 MS
  • Protection against reverse polarity
  • Operating temperature: -25 °C to +55 °C
  • Diameter: 18 mm
  • Sensor length: 45 mm

 

Description

Adjustable, digital distance sensor with a cable length of 50 cm and nuts to facilitate mounting. Measurement range from 3 to 50 cm, is set using the knob located at the rear part of the device - clockwise rotation less range.

 

Object detection is indicated through the occurrence of a state of a low level at the output (yellow wire) and the switching on of the red led. The advantage of the sensor is also protected against reverse power connection.

 

Connection

  • Red wire - power supply - 5 V
  • The green wire is GND
  • Yellow wire - output - OUT
    • there is no object - state, high
    • the object discovery - as low
 
The 5 V supply voltage digital output to do that the sensor can be connected directly to the pins of the most affordable on the market of microcontrollers in AVR and STM32 and sets in Arduino and Raspberry Pi.

The product is compatible with Arduino

The user manual is available on our website.

For proper operation, it is sufficient to connect power 5 Volts and the sensor output to any digital contact Arduino. Reading works by calling a standard function digitalRead(numer_pinu).