The system allows you to control a stepper motor using a device that allows you to generate the logical state, for example, Aa rduino, STM32Discovery, Raspberry Pi. The module is characterized by a very simple operation, compatible with engines krokowymi 4, 6 and 8 wired.
|The system can be configured to work with voltages of 3.3 V. this requires dolutować the jumper marked with 3/5V.|
Voltage zasalania of the motor must be connected to terminals labeled PWR IN - the positive pole of M+, ground, GND. The findings of the stepper motor are connected to the contacts of the MOTOR - coil A and B. Control is via pins DIR (direction) and STEP (step). In the case when signals strujące feed from a different source than the voltage for the motor you must also connect the ground of the control system to terminal GND.
In order to rotate the motor one step, you must specify the STEP output high (logical unit), another sequence of zeros and ones moves the motor one step, etc. the Choice of direction is accomplished by depositing as the output DIR (e.g., low - speed clockwise, as high - on the contrary). The driver also has the choice of resolution of operation of the engine.
The connection and disconnection of the engine while the driver is turned on can damage the system.
The step size is selected via the inputs MS1, MS2. Possible settings are shown in the table below. Inputs MS1, MS2 and MS3 have a built-in resistor pull-up (10 kω), so by default, the system works in a mode 1/8 steps.
Easy Driver module allows the active current limit with the potentiometer. One of the ways the introduction of restrictions to set the driver to full step and measuring the current passing through one coil without signal at the input STEP.
STM32F407G-DISC1 - Discovery - STM32F4DISCOVERY* - 105,00 zł
A4988 - stepper motor driver - 19,90 zł
Baby Orangutan B-328 Robot Controller_ - 85,00 zł
ATmega8 mini module - microBOARD-M8_ - 29,90 zł
Arduino Uno Rev3 - module A000066* - 92,00 zł
SAME DAY SHIPPING
Posting the payment for the order on our account on a business day up to 13:00 means sending the goods on the same day!
The time of payment depends on the hours of ELIXIR session of the sender's bank and the recipient of the transfer (more information on this subject, for example on the websitehttp://www.kiedy-przelew.pl/).
The table presents available forms of delivery in Poland
|9,90 PLN||17,90 PLN||1-3 days|
|14,90 PLN||22,90 PLN|
|12,90 PLN||-||1-3 days|
If the amount to pay for products exceeds 500 PLN