Step-Down Voltage Regulator D24V25F9 - 9V 2,5A - Pololu 2854

Index: PLL-03158 EAN: 5904422372477

Step-down converter with 9 V output voltage. The maximum current is 2.5 A. The supply voltage is in the wide range from 10.5 V to 38 V. The module dimensions are 18 x 18 mm.

Step-Down Voltage Regulator D24V25F9 - 9V 2,5A - Pololu 2854
€21.00
€17.07 tax excl.
Available
Shipping in 24 hours
PayPal payment
D24V25F inverter - voltage:
Manufacturer: Pololu

Product description: D24V25F9 - step-down converter - 9 V 2.5 A

A step-down converter (buck) used to power systems operating at 9 V. The advantage of the system is a wide range of input voltages from 10.5 V to 38 V. D24V25Fx module allows for current consumption up to 2.5 A.

Outputs

Pin Description
VIN Input voltage.
GND Mass potential.
VOUT Output voltage.
ENABLE If a low voltage of less than 0.6 volts is applied), the system will go into a low power consumption state (approx. 20 μA). The pin is pulled to the supply voltage through a 100 kΩ resistor, which makes the system switched on by default.

Przetwornica impulsowa step-down wyprowadzeniami goldpin

The connectors are properly signed on the board. Outputs are 2.54 mm (popular goldpin connectors). The module can be plugged into acontactboard,connected with wiresor soldered intoa dedicated PCB.

Przetwornica impulsowa step-down wyprowadzeniami goldpin

System efficiency

Efficiency is defined as the ratio of output power to input power (Power out)/(Power in). This is a very important parameter when working with portable energysources(batteries and accumulators), where the time of operation on one charging cycle counts. The efficiency of this pulse system is about 85% to 95%.

Voltage drop-out

The parameter referred to in the documentation asvoltag drop-outthennecessary for the proper functioning of the system,minimum difference between input and output voltage.For example, if the drop-out is 1 V and the desired output voltage is 5 V, the supply voltage should be higher than 6 V. The figures below show the drop-out voltage value for D24VxFx inverters.

Specification

  • Input voltage: 10.5* V to 38 V
  • Output voltage: 9 V
  • Accuracy of output voltage: 4%
  • Maximum input current: 2,5 A
  • Efficiency of 85% to 95%
  • Integrated protection against excessive current, voltage and temperature
  • Two 2.2 mm diameter mounting holes
  • Dimensions: 18 x 18 x 9 mm
  • Weight (without connectors): 3,0 g

* minimum value depending on drop-out voltage

Length 18 mm
Width 18 mm
Height 9 mm
Voltage to 10.5 V
Voltage from 38 V
Voltage output from 9.0 V
Output voltage to 9.0 V
Nominal output voltage 9.0 V
Current 2.5 A
Stabilizer - Type2 switching
Stabilizer - Type step-down
Package width 8 cm
Package height 9.5 cm
Package depth 0.8 cm
Package weight 0.004 kg

Be the first to ask a question about this product!

Customers who bought this product also bought:

Products from the same category: