Categories

Pololu Step-Down Voltage Regulator D24V6AHV - 15V 0,5A

The module switching converters step-down with an efficiency of about 80 % - 93 %. Converts the input voltage in the range from 15.1 V to 36 V output of 15.0 V. the Maximum continuous current of 0.5 A.

More details

PLL-03114

Dodano produkt do koszyka

Czas oczekiwania ok. 10-21 dni

Price 21,90 zł

Description of product: Pololu D24V5F15 Converter step-down - 15 to 0.5 A

The regulator switching DC-DC converts the input voltage in the range of 15.1 V* up to 36 V on the output value of 15.0 V. Allows quiescent current to 0.5 A. The system is characterized by high efficiency at 80 % - 93 %.

 

Pololu D24V5F15 - przetwornica step-down - 15V 0,5A

Pololu D24V5F15 Converter step-down - 15 V 0,5 A.

In our offer available version with an output voltage of : 1.8 V, 2.5 V, 3.3 V, 5V, 6V, 9V, 12V and 15V.

 

Insights

The module has four output:

  • VIN - input voltage.
  • GND - the ground.
  • VOUT - output voltage.
  • SHDN - input low (<0.4 V) puts the system into the mode of low consumption of energy, where he received only 10 ° C - 20 ° C for every Volt of supply voltage. Pin by default is chosen based on VIN through a resistor of 100 k?. If low-power is not used SHDN can be left not connected.

 

In the holes, you can solder a popular strap goldpin findings raster is 2.54 mm (included in delivery). The module can be mounted on the contact plate, connect via wires or put in a dedicated circuit Board.

Efficiency and output current

Efficiency is defined as the ratio of output power to input power (Power out)/(Power in). This is a very important parameter for portable energy sources (batteries and accumulators), which has a value of working time on one cycle charging. The dependence of the efficiency on the input voltage given in the diagrams below.

 

 

Voltage drop-out

The graph below shows the dependence of the voltage drop-out from the value of the output current. For example, if consumption of 300 m the output voltage must be higher than 0.5 V input.

 

Hazardous voltage pulses

When connecting power to the module, can appear dangerous, eclectic short pulses of high amplitude (so-called pins), which can damage the system. Test company, Pololu, it follows that for voltages above 20 Volts , the pins can have an amplitude in excess of 42 Volts. To protect against this undesirable phenomenon wlutowanie recommended capacitor value of at least 33 uF / 50 V as close as possible to the power pins of the Converter.

Technical characteristics of the transmitter

  • Input voltage: 15,1 V* up to 36 in
  • Output voltage: 15 V
  • Output voltage accuracy: 4 %
  • Maximum output current: 0.5 A
  • Switching frequency: 500 kHz
  • Built-in protection:
    • before a too large current consumption
    • from too high temperature
  • Driver: ISL85415 (documentation)
  • Dimensions: 13 x 10 x 3 mm
  • Weight: 1 g (without connectors)

 

* Lower limit of input voltage depends on the voltage drop-out details on the chart.

  • Length 13 mm
  • Width 10 mm
  • Height 3 mm
  • Voltage to 15.1 V
  • Voltage from 36 V
  • Voltage output from 15.0 V
  • Output voltage to 15.0 V
  • Nominal output voltage 15.0 V
  • Current 0.5 A
  • Stabilizer - Type2 switching
  • Stabilizer - Type: step-down

SAME DAY SHIPPING

Posting the payment for the order on our account on a business day up to 13:00 means sending the goods on the same day!

 

The time of payment depends on the hours of ELIXIR session of the sender's bank and the recipient of the transfer (more information on this subject, for example on the websitehttp://www.kiedy-przelew.pl/).

 

The table presents available forms of delivery in Poland

 

Carrier and
regulations

Bank wire
transfer

Payment
by cash

Delivery
time

Poczta Polska

terms of service

9,90 PLN17,90 PLN1-3 days

Kurier GLS

terms of service

14,90 PLN22,90 PLN

1-2 days

Paczkomaty 24/7 

terms of service

12,90 PLN-1-3 days

If the amount to pay for products exceeds 500 PLN
Delivery is for free!

 

  • Free delivery of orders over 500 PLN does not apply to parcels addressed outside of Poland.
  • Free delivery does not apply when changing orders.
  • The delivery period is counted in working days from the date of dispatch of the order.