- EOL
|
Attention! Model replaced by a new version:Fingerprintreader- TTL GT-511C1R |
Product description: Fingerprint reader - TTL GT-511C1 - 20 prints memory.
Fingerprint reader module equipped with a 32-bit microcontroller, communicating by means of simple commands sent through a serial interface (RX, TX). The sensor has a memory that allows you to store up to 20 fingerprints and transfer data in the form of photos or a database of patterns to a computer via a USB-UART adapter, microcontroller or otherreader.
Side hooks with holes of 2.5 mm in diameter facilitate mounting of the module. The JST-SHconnector is used to connect signals.The system has four outputs:
- VCC- supply voltage
- GND- system weight
- RX- serial interface UART receiver
- TX- serial interface UART transmitter
On the first start-up, the fingerprint to be saved in the database should be scanned after sending an appropriate command via the serial interface. Detailed description can be found in thedocumentation.The list of commands can be found in section 3 on page 9.
The module cooperates with microcontrollers equipped with serial interface (RX, TX lines), including Arduino and Raspberry Piminicomputer.
|
Product compatible with Arduino The manufacturer has prepared anapplicationand asample code with a library for Arduino, which is available on GitHub. |
The film was made by SparkFun company showing the possibilities of the product.
Specification .
- Power supply voltage: 3,3 - 6 V
- Current consumption: up to 130 mA
- The outputs operate at 5 V
- Simple UART serial interface - 9600 bps
- Resolution 450 dpi (216 x 240 px)
- Memory for up to 20 fingerprints
- Number of flash memory write cycles: 20 000
- High scanning accuracy - SmackFinger 3.0 algorithm
- Possibility to send a fingerprint image to a computer or microcontroller
- Possibility of saving the formula to the database
- Two mounting holes of approx. 2.5 mm diameter
- Module dimensions: 37 x 17 x 9.5 mm
Useful links |
