• EOL

Sine/rectangle signal generator DDS AD9850 40 MHz

Index: MOD-02721 EAN: 5904422331122

The module can generate the following signals: 2 x sine, 2 x rectangular with frequency up to 40 MHz. The system communicates via a serial bus, or by sending the bits in parallel. It is supplied with the voltage of 3.3 V or 5 V.

Sine/rectangle signal generator DDS AD9850 40 MHz
€17.90
€14.55 tax excl.
Unavailable
Discontinued product
PayPal payment
Manufacturer: OEM

Attention!

The product has been discontinued. Check other products in category.

Item description: signal Generator sine / rectangle DDS AD9850 40MHz

The module can generate the following signals: 2 x sine, 2 x rectangular with frequency up to 40 MHz. The system communicates via a serial bus, or by sending the bits in parallel. The maximum frequency of the generated signal is 40 MHz, the command word consists of 32 bits. It is supplied with the voltage of 3.3 V or 5 V.

  

Generator sygnału sinus

The product is compatible with Arduino

On our website you will findthe textbook along with a sample programfor Arduino users.

 

Technical characteristics of the generator

  • Supply voltage: from 3.3 V to 5 V
  • Communication: serial interface or a parallel bus is 1 byte
  • Potentiometer to adjust the rectangular fill
  • Outputs:
    • 2 x sinusoidal signal
    • 2 x rectangular signal
  • Conclusions: connectorsgoldpin raster 2.54 mm
  • Four mounting holes 3 mm in diameter
  • Module dimensions: 45 x 25 mm

 

Connection

The module has solderedconnectors goldpin raster 2.54 mm, which allows you to connect it tothe breadboard or via connectingwire.

Pin Description
VCC

Supply voltage from 3.3 V to 5 V.

GND Module's ground
W_CLK The clock signal of the communication bus.
FQ_UD Changing the frequency, if a rising edge appears on this pin, the system will update the frequency to the value specified in the input register.
DATE The data line of the serial interface.
RESET Reset the module, a high signal removes the data from all registers of the system.
D0-D7 8-bit bus parallel: D0=LSD, D7=MSB.
ZOUT1 The output signal of the sine signal No. 1.
ZOUT2 The output signal of the sine signal No. 2.
QOUT1 The output of the rectangular signal No. 1.
QOUT2 The output of the rectangular signal No. 2.
Potentiometer Used to adjust the fill of the rectangular signal.

 


Be the first to ask a question about this product!

Customers who bought this product also bought:

Products from the same category: