• EOL

NanoPi NEO v1.4 - Allwinner H3 Quad-Core 1,2GHz + 256MB RAM - with headers

Index: NNP-14634 EAN: 5904422342548

Miniature NanoPi computer in Neo 1.4 version with 1.2 GHz Allwinner H3 quad-core ARM Cortex-A7 processor. The board has 256 MB of DDR3 RAM, built-in Ethernet port and USB + 2 x USB Host slot on 2.54 mm pins, 36 GPIO, microSD card slot. Works with u-boot and UbuntuCore systems.

NanoPi NEO v1.4 - Allwinner H3 Quad-Core 1,2GHz + 256MB RAM - with headers
€22.50
€18.29 tax excl.
Unavailable
Discontinued product
PayPal payment
Manufacturer: FriendlyARM

Attention!

The product has been discontinued. Check other products in category.

Description: NanoPi NEO v1.4 - Allwinner H3 Quad-Core 1.2GHz + 256MB RAM - with connectors.

MiniatureNanoPicomputer inNeo v1.4version with1.2 GHzAllwinner H3 quad-coreARM Cortex-A7processor. The board has256 MB ofDDR3 RAM, built-in portEthernetand aUSB + 2x USB Host slot on2.54 mm,36 GPIOpins, microSD card slot. Works withu-boot and UbuntuCoresystems.Version v1.4 has 4-pin audio interface, 2-pin CVBS interface, supports IC power control and has holes for heatsink mounting.

NanoPi Neo v1.4

The advantage of the tile is its small dimensions, the tile outline is 40 x 40 mm.

The device has a USB port, connector and Ethernet port and many others.

What is needed to run a NanoPi minicomputer?

Operating system for NanoPi Neo

NanoPi works with systems prepared by the manufacturer: u-boot and UbuntuCore. The disk of the device can be a microSD card, which can be purchased in our shop.

Operating systems can be downloaded fromthe manufacturer's website.The manufacturer also provides asystem installation guide.

NanoPi Neo v1.4

GPIO pinout layout - the pins were soldered in the factory.

Communication of NanoPi Neo minicomputer

The minicomputer has basic communication interfaces that can be found in PC-class office computers. In addition to the previously mentioned audio and video interfaces, the user has the possibility to use them:

  • 1x USB A + 2x USB Host connector on 2.54 mm pins,under which you can connect e.g. a mouse, a keyboard, a WiFi card or a flash drive. If it turns out that there are too few sockets, you can increase their number usingan external USB HUB. The interfaces on the pins can be connected with cables.
  • Ethernet socket, i.e. possibility of direct connection to the LAN.
  • GPIO x 36 pin- general purpose outputs/inputs that can be used to operate LEDs, buttons,motorcontrollers. Among them there are pins supporting interfaces: I2C, SPI and UART. Pins should be soldered on their own,goldpin raster strips 2.54 mmcan be purchased in our shop.
  • microSD slot- a slot for a microSD memory card, on which the operating system can be installed.

NanoPi Neo power supply

The system uses the microUSB connector as the power source. The manufacturer recommends that the voltage given on the connector should be 5.0 V, while the current capacity of the power supply used should be at least 2.0 A. In our offer you will findpower supplies meeting these parameters.

Radiator z taśmą termoprzewodzącą do NanoPi NEO

In our offer you will also finda dedicated heat sink.

Specification

Model NanoPi Neo
Specification
Processor Allwinner H3
Core Quad-Core ARM Cortex A7
Systems u-boot
UbuntuCore
Clocking 1.2 GHz
Memory RAM 256 MB
4901Memory microSD card
GPIO socket 36-pin connector
Power supply 5 V / 2 A - microUSB
Dimensions of the tiles 40 x 40 mm
Interfaces
USB Host 1 x USB socket A
2 x USB Host on 2.54 mm pins
Network interface Ethernet 10/100 Mbps
Video -
Audio audio output and microphone
on GPIO connector
Communication UART, SPI, I2C, GPIO, PWM
Debugger Serial port 4pin / 2.54mm
Additional Built-in LED
CVBS 2-pin interface
Supports IC power control
Heatsink mounting holes
UC - Microcontroller Allwinner H3
UC - Core Cortex A7
UC - RAM 256 MB
UC - core 4. Quad Core
UC - Digital pins 30
UC - External memory microSD card
UC - freq 1.2 GHz
UC - Ethernet yes
UC - USB microUSB
UC - microSD yes
UC - HDMI no
UC - I2C yes
UC - UART yes
UC - Connector 5V microUSB
UC - SPI interface yes
UC - LCD interface no
UC - Camera interface no
UC - Linux yes
UC - Android no
UC - Windows no
Package width 7.7 cm
Package height 3.2 cm
Package depth 11.2 cm
Package weight 0.045 kg

Be the first to ask a question about this product!

Customers who bought this product also bought:

Products from the same category: