Grove - PIR motion sensor

Index: SEE-11343 EAN: 5904422350031

Motion sensor type PIR interface is compatible with Grove series. Object detection is indicated by a digital position in a high pin SIG. The range can be set within the range of from 0.1 to 6 m and a response time of between 0.3 and 25 seconds. The sensor is compatible with Arduino, Raspberry Pi and other microcomputers/controllers. The kit also includes a Grove cable.

Grove - PIR motion sensor
€9.90
€8.05 tax excl.
Available
Shipping in 24 hours
PayPal payment
Manufacturer: Seeedstudio
Compatibility: Arduino Raspberry Pi

Description

Motion sensor type PIR interface is compatible with Grove series. Object detection is indicated by a digital position in a high pin SIG. The range can be set within the range of from 0.1 to 6 m and a response time of between 0.3 and 25 seconds. The sensor is compatible with ArduinoRaspberry Pi, BeagleBone Forward, LinkIt ONE and other microcomputers/controllers. The kit also includes a Grove cable.

Grove - czujnik ruchu PIR

Service

Simply connect the sensor with the Grove wire intended for that connector on the Board Seeeduino or, in the case of the Raspberry Pi and other mini computers, according to the table below. The range and reaction time can be adjusted using potentiometers (not included), which must be soldered to the board.

Pin Description
VCC Supply voltage from 3.3 V to 5 V.
GND The ground of the system.
SIG Digital output indicates motion detection.


The manufacturer provides on its website a simple connection scheme for Arduino (Seeeduino) and Raspberry Pi together with the codes sources.

It can be used to create, for example:

  • Alarm system
  • Automation systems
  • Switch
  • Motion detector

Specification

  • Supply voltage: 3 V to 5 V
  • Current consumption (3 V): 100 µa
  • Current consumption (5 V): 150 mA
  • Range: from 0.1 m to 6 m (3 m)
  • Response time: 0.3 sec to 25 sec
  • Wave length: from 7 µm to 14 µm
  • Viewing angle: 120 °
  • Sensor lens: Fresnel 8120
  • Controller: BISS0001
  • Dimensions: 40 x 20 x 15 mm
  • Weight: 12 g

Voltage to 3.3 V
Voltage from 5.0 V
Sensor - type PIR
Sensor - assembly for case
Package width 8.7 cm
Package height 14 cm
Package depth 1.5 cm
Package weight 0.012 kg

Kacper

01/21/21

Question: How do we adjust the detection range 0.1 - 6m?
Answer: To adjust the detection range, solder a potentiometer in the place marked R2 on the board, more information can be found on the manufacturer's wiki page:
https://wiki.seeedstudio.com/Grove-PIR_Motion_Sensor/#faqs

Customers who bought this product also bought:

Products from the same category: