Product description: Case forRaspberry Pi 4B- Acrylic with 5V fan - Black - PiHut TPH-001
Fan case forRaspberry Pi 4. The case elements are made and laser cut out ofacrylic. The enclosure hasa 5-volt fanand numerous air vents to protect the minicomputer while maintaining adequate airflow. The product was manufactured in theUK. The fan should be connected to the GPIO Raspberry Pi 4 and 6 pins.
| On our blogthere is a temperature test showing howRaspberry Pi 4Bcan be tampered with. |
The kit includes the enclosure and the necessary mounting elements,Raspberry Pi 4Bmust be purchased separately.
Diagram of connecting the fan to pins 4 and 6 on GPIO Raspberry Pi.
Installation of the case
- Remove the protective film from the housing components before installation.
- Attach shorter distances to the lower black panel using 4 mm screws.
- Place the Raspberry Pi so that the ends of the distances go through the mounting holes in the minicomputer board.
- Screw the longer distances to the already installed ends.
- Insert the side elements into the prepared cut-outs in the lower panel.
- Screw the fan to the transparent panel of the enclosure, and position the fan with the PiHut sticker towards the minicomputer.
- Connect the fan to pins 4 and 6 on the GPIO and put the top part of the case on so that it will fit into the side elements' grooves.
- Tighten the top part of the case with screws for longer distances.
| Tighten the screws carefully to avoid damaging the acrylic. |
The kit includes
- Housing elements made of acrylic
- Fan 5 V
- Necessary assembly elements
Housing specifications
- Material: Acrylic
- Colour: Black and transparent top panel
- Fan: 5 V, 2 pin, 30 x 30 x 8 mm
Main components of the housing.
