The module consists of a printed circuit board made for the system Allegro ACS714LLCTR-05B-T. The sensor operates based on the Hall effect. The chip can be powered from a voltage in the range: 4.5 V to 5.5 V.
Basic module features:
The sensor requires a supply voltage in the range from 4.5 V to 5 V, connected to the pins designated as VCC (+) and GND (ground). The output is a voltage signal proportional to the intensity of the measured current. When the voltage VCC is equal to 5 V, the output is centered on the half, that is 2.5 V. The output value increases by 185 mV at 1 A when the strength of the measured current is positive, otherwise, it decreases.
The chip has an internal resistance filter of 1.7 kΩ, the board has the condenser with the value of 1nF, which together form a low pass filter with cut-off frequency of 90 kHz. The user can change the filter when the capacitor is output onis called "filter". The limit frequency can be calculated by the formula:
F = 1 / (2πRC) = 1 / (11kΩ * (1 nF + Cf))
where Cf is the capacitance of the capacitor soldered into the "filter" pins.
STM32F407G-DISC1 - Discovery - STM32F4DISCOVERY* - 109,00 zł
TB6612FNG - two-channel motor controller - 9,20 zł
Arduino Uno Rev3 - module A000066* - 92,00 zł
SAME DAY SHIPPING
Posting the payment for the order on our account on a business day up to 13:00 means sending the goods on the same day!
The time of payment depends on the hours of ELIXIR session of the sender's bank and the recipient of the transfer (more information on this subject, for example on the websitehttp://www.kiedy-przelew.pl/).
The table presents available forms of delivery in Poland
|9,90 PLN||17,90 PLN||1-3 days|
|14,90 PLN||22,90 PLN|
|12,90 PLN||-||1-3 days|
If the amount to pay for products exceeds 500 PLN