The module consists of a printed circuit board made for the system Allegro ACS711. The sensor operates based on the Hall effect. The chip can be powered from a voltage in the range: 3 V to 5.5 V.
The sensor requires a supply voltage in the range from 3 V to 5.5 V, connected to the pins designated as VCC (+) and GND (ground). The output is a voltage signal proportional to the intensity of the measured current. When the voltage VCC is equal to 5 V, the output is centered on the half, that is 2.5 V. The output value increases by 45 mV at 1 A when the strength of the measured current is positive, otherwise, it decreases.
Formulae allowing to calculate the output values:
The FAULT pin is in the high status by default. It reaches a low status when the measured current exceeds the range of ±31 A. The only way to reset the FAULT flag is disconnecting and then re-connecting the power supply - VCC.
The system is designed to work with voltages up to 30 V. Higher values can pernamently damage the module.
The module includes the passive components necessary for proper operation of the ACS711 sensor.
SAME DAY SHIPPING
Posting the payment for the order on our account on a business day up to 13:00 means sending the goods on the same day!
The time of payment depends on the hours of ELIXIR session of the sender's bank and the recipient of the transfer (more information on this subject, for example on the websitehttp://www.kiedy-przelew.pl/).
The table presents available forms of delivery in Poland
|9,90 PLN||17,90 PLN||1-3 days|
|14,90 PLN||22,90 PLN|
|12,90 PLN||-||1-3 days|
If the amount to pay for products exceeds 500 PLN