Description
The FireBeetle module compatible with Arduino, equipped with LoRa SX127x 433 MHz module with built-in PA (Power Amplifier), controlling is through SPI interface. It is used for wireless communications with a frequency of 433 MHz. It is designed for IoT projects (Internet of Things). The module is powered with a voltage of 3.3 V.
The set also includes a set of goldpin connectors and antenna connector for self-assembly along with antennawire.
The module supports long-range monitor, FSK modulationsand the maximum transmission of 300 Kb/sec. LoRaTM is also supported, the maximum transmission is 37.5 KB/sec. The current is less than 0.2 µA in low power mode. It can be used in home automation, health monitoring, intelligent clothes, and more.
Leads
The module communicates via the SPI interface (MISO, MOSI, SCK, CS, RESET). You must connect these pins to the MISO, MOSI, SCK on FireBeetle, CS and the Reset board toconnectors D2, D3, D4, D5 with Dupont wires. Read more inthe manualprepared by the manufacturer.
Specification
- Working voltage: 3.3 V
- Working frequency: 433MHz
- Modulation type: LoRaTM / FSK / GFSK / OOK
- Output power: up to 20 dBm
- Reception frequency: -139 dBm
- Surfacing current: up to 120 mA
- Reception current: under 15 mA
- Current in a sleep mode: up to 1µa
- Transmition power: -1 dBm to 20 dBm
- Transmition mode: FIFO / DMA
- Working frequency: 403 MHz to 463 MHz
- Transmission range: 1 Km
- Built-in antennas provide good thruput
- RSSI: max 127 dB
- The size of the FIFO: 256 B
- Supports:Frequency-hopping
- Control via SPI interface
- GPIO interfaces: 5 (it can be used as interrupts.)
- Working temperature: -20℃ to 70℃
- Dimensions: 58 x 29 mm
Set includes
- Module FireBeetle LoRa 433MHz
- 2x goldpin strip 18-pin 2.54 mm
- 2x goldpin strip with long pins, 18-pin of 2.54 mm
- 1x 433MHz antenna IPEX
- 1x antenna connector SMA-KE
Useful links |
