- EOL
|
Attention! The product has been discontinued. Check others products incategory. |
Description
The module is an extension for moduleArduinothat connect to Ethernet network. The service is simplified by the library together with intuitive documentation and numerous examples. Shield is also a reader ofmicroSDmemory cards, which allows to store more data. This version hasa PoE modulethat provides power to the chip with voltage of 12 V from the Ethernet connector.
The subject of the sale is the Ethernet Shield with the option of power over Ethernet,the Arduino modulemust be purchased separately.
| In our offer available is version without PoE module. |
Specification
- Working voltage: 5 V (powered from Arduino pins)
- Ethernet controller: W5500 with buffer of 32 KB
- Data transfer rate: 10/100 MB
- Communication: SPI bus
- Built-in PoE module (Power Over Ethernet)
- Power supply from the Ethernet network
- The input voltage PoE: 36 to 57 V
- Output voltage PoE: 12 V
- Efficiency: approx. 85 %
- The short-circuit protection
- Compliant with IEEE802.3af
- Built-in microSD memory card reader
- Available from the level of a standard SD Card library
- Pin SS of the SPI bus is at the pin no. 4
- Built-in RJ45 connector
- The possibility to connect the module PoE - power over Ethernet
- The module has the following status LEDs:
- ON - signals the proper powering
- LINK - indicates a connection to the network
- FDX - indicates the connection in full duplex mode
- 100M - indicates the communication with the speed of 100 Mbit/s
- ACT - flashes when using pins RX and TX
- Led out RESET button of the Arduino
- Shield is compatible withArduino UnoandMega(does not support Arduino Zero M0 Pro)
In addition to the Ethernet slotr and the card reader, device has: connectors for PoE module, leads of Arduino pins, RESET button, LEDs, and additional slots to the communication buses, for example, TWI (I2C).
ThingSpeak platform for Arduino and Raspberry Pi IoT.
Useful links |
