• EOL

SafeHaus SHG-01 - natural gaz sensor - 230V

Index: TER-15537

SensorSHG-01 by SAFEHAUSis designed to monitor rooms for escaping natural gas. It is powered by230 V.The sensor has a certificate confirming that it meets the requirements of the Polish standard EN50194-1:2009, which allowsit to be installed not only in homes but also in commercial and service premises. In case of gas detection an optical-acoustic alarm is activated.

SafeHaus SHG-01 - natural gaz sensor - 230V
€30.90
€25.12 tax excl.
Unavailable
Discontinued product
PayPal payment
Manufacturer: SafeHAUS

Attention!

The product has been discontinued. Check other products incategory.

Product description: SafeHAUS SHG-01 Natural Gas Sensor - 230 V

The SHG-01 sensorby SAFEHAUS is designed to monitor rooms for escaping natural gas. It is powered by 230 V. The sensor has a certificate confirming that it meets the requirements of the Polish standard EN50194-1:2009, whichallows it to be installed not only in homes but also in commercial and service premises. In case of gas detectionan optical-acoustic alarmis activated.

Czujnik gazu ziemnego SAFEHAUS SHG-01SAFEHAUS SHG-01 natural gas sensor.

Installation of SafeHAUS SHG-01 natural gas sensor - 230 V

As the gas from the gas installation is lighter than air in the event of a leak, it starts to collect under the ceiling and fill the room from above, so the sensor should be installed about 30 cm from the ceiling in a place where air movement will not be disturbed. Also make sure not to installthe sensor:

  • Directly above kitchen appliances (gas stove, cooker, burner, etc.).
  • In external areas
  • In an enclosed space (e.g. a loose cabinet behind a curtain)
  • Directly above the sink and in humid places
  • Next to doors and windows
  • Next to the exhaust fan or hood
  • In places where the temperature may fall below -10 °C or exceed 40 °C
  • In places where dirt and dust can clog the device

The table below shows the operating status of the device and the status of the notifications that occur.

StatusDescription

Green

POWER LED

Yellow

FAULT diode

Red

ALARM diode

Beacon

audio

Auto test

Power on It lights up . It lights up . It lights up . 1 beep

Warming up

Approximately 180 seconds after start-up Blinks 0.5 s / 1 s It doesn't shine It doesn't shine Excluded

Vigil

Normal work Lights steady It doesn't shine It doesn't shine Excluded

Test

Testing the device after pressing

TEST/HUSH button

Lights steady It doesn't shine Blinks 0.5 s / 1 s ALARM diode spades

ALARM

The device detected the gas Lights steady It doesn't shine Blinks 0.5 s / 1 s ALARM diode spades

Mute

Press the TEST/HUSH button

during the alarm

Lights steady It doesn't shine Blinks 0.5 s / 1 s Excluded

Sensor malfunction

Contact the service Lights steady Lights steady It doesn't shine 1 beep every 30 seconds
Special functions

The device should

swap for new ones

Lights steady Lights steady It doesn't shine 3 beep every 30 seconds

Memory

Embedded

The power cable is disconnected It doesn't shine It doesn't shine It doesn't shine Excluded

If an alarm sounds, be calm and do the following:

  • Switch off all gas appliances
  • Open doors and windows to increase ventilation
  • Do not turn on or off any electrical devices, including gas detectors
  • Switch off the gas supply by shutting off the main valve in the building
  • Do not use the phone in a gas room
  • Contact the gas service or its supplier

Attention!

Before connecting, please read the supplied manual.

After connecting the power supply the sensor needs about 3 minutes for calibration.

We also offer otheralarmsensors.

SAFEHAUS SHG-01 - 230 V natural gas sensor specification

  • Power supply: 230 V AC
  • Sensor type: solid-state
  • Detects: natural gas / methane
  • Certificate of conformity to EN50194-1:2009 issued by BSI
  • Sensitivity: 6% DGW (Lower Explosion Limit)
  • Volume: >85 dB at 1 meter distance
  • Energy consumption:< 4 W
  • Operating temperature: -10 °C to 40 °C
  • Operating humidity: 0 to 95 % RH
  • Dimensions: 117 x 77 x 36 mm
  • Lifetime: approx. 5 years

Sensor - service ready-to-use device
Package width 12.2 cm
Package height 15.4 cm
Package depth 5.6 cm
Package weight 0.307 kg

Be the first to ask a question about this product!

Customers who bought this product also bought:

Products from the same category: