The power supply for the Raspberry Pi minicomputer that acts as an emergency power supply because of a power outage.
Shield for Raspberry Pi acting as an emergency power when you connect the battery Li-Pol 3.7 V (included 300 mAh). It has 5 indicative LEDs and real-time clock. It supports the cascade connection to the shields. It can be used with any module connected to the GPIO pins. The advanced edition works with a wider power supply range - from 7 V to 24 V.
Extension for Raspberry Pi working as an emergency power supply when you connect the battery Li-Pol 3.7 V (included 300 mAh). It has 5 indicative LEDs and real-time clock. It supports serial connection of the extensions. It can be used with any GPIO module. Version Advanced Mobile works with a wide power supply range from 7 V to 24 V...
Extension for Raspberry Pi working as an emergency power supply when you connect the battery Li-Pol 3.7 V (included 300 mAh). It has 5 indicative LEDs and a real-time clock. It supports the serial connection to the hats. It can be used with any device connected to the GPIO pins. This extension allows you to run the Raspberry Pi using only battery power.
Cap for Raspberry Pi acting as emergency power when you connect a lipol battery 3.7 V. It has 4 information LEDs. Supports the cascade connection to the caps. Can be used with any module connected to the GPIO pins.
Portable power supply platform for a min-computer Raspberry Pi. The module is based on ARM Cortex-M0. It has the original battery 1820 mAh from the Mororolla Droid 2 with the possibility of expanding with a battery with a capacity of 5000 mAh or even 10000 mAh. The battery can be charged using renewable energy sources such as solar or wind energy.
LiPo PWM is an extension for Raspberry Pi mounted directly on the GPIO connector of the minicomputer. The device has JST 2.0 mm 2-pin connectors for connecting the reachargeable battery Li-Pol or Li-Ion to power the Raspberry Pi. This extension is not a charger.
Module in the form of a hat for Raspberry Pi, which allows to supply power to a minicomputer with voltage from 3 V to 16 V. This allows the cooperation of different power supplies with Raspbery Pi. The set also includes a wire with 5.5/2.1 mm plug and a wire with wires with removed insulation.
Trim that to food minikomputera Raspberry Pi version 4B and 3B+ directly to the Ethernet port, located on the Board. In addition, the panel was equipped with an active cooling fan. The input voltage is 37 Volts to 57 Volts, but the output is 5 V / 3 A.
Panel providing power to a minikomputera Raspberry Pi with the battery level. Integrated Arduino and RTC allow you to control the power consumption, which ensures a longer operation. The module automatically switches to emergency power and will. PH connector 2.0 is used to connect the batteries with a voltage from 7 V to 28 Volts.