The modules run with a wireless interface Z-wave.
Electronic thermostatic head designed to control heaters with adapters RA-N and M30 x 1.5. Controlled via a built-in three-buttons or remotely via the Z-Wave controller. The device has easy to read display with backlight. Power is provided by two AA batteries.
The module connects serial transmission with Z-Wave protocol. On the basis of the Z-Wave module 300 loaded with firmware Z-Wave.Me and 32 KB memory EEPROM. It has 5-pin connector UART, and an aerial connector u.FL. Module dimensions: 32 x 27x 7 mm.
Module changing Raspberry Pi into a gateway for the Z-Wave home automation Z-Wave. Allows to control the devices via smartphone or web browser. The interface uses Java Script - JSON - on the embedded web server. The module is connected to the GPIO pins of the Raspberry Pi.
Module connecting the capabilities of the Protocol Z-Wave and Arduino board. It allows you to control home automation devices using the Arduino microcontroller. It has 26 digital inputs/outputs, 5 PWM channels, 4 analog inputs, popular communication interfaces and 2 timers. Operating outputs voltage is 5 V.
LED light bulb powered by 230V with E27 screw. Consumes only 9 watts. It has a built-in Z-Wave Protocol receiver, so it can be controlled remotely and wirelessly. The lamp can shine in: any color from the RGB palette, warm white, or cold white.
LED light bulb powered by 220-240V with E27 screw. Consumes only 9 watts. It has a built-in Z-Wave Protocol receiver, so it can be controlled remotely and wirelessly. The lamp can shine in: any color from the RGB palette, warm white, or cold white.
AEOTEC LED Light Bulb 6 Multi-Color powered by 220-240V voltage, 50 Hz, with E27 thread. It consumes only 9.5 W of power. It has a built-in Z-Wave Protocol receiver so it can be controlled remotely and wirelessly. The bulb can shine in any color from the RGB palette, in warm white or in cold white.
Thermostatic head electronic system which controls the temperature of radiators. Installs using the supplied adapters RA-N and M30 x 1.5. The temperature value is displayed on the front of the head display. The device is controlled by Z-Wave controller or via 3 buttons located on the front of the device.