Lining for Arduino is equipped with a different connector, solder field and popular communication interfaces.
Shield for Arduino Uno Rev3 and derivatives allow you to create your own shields. It has led out all the connectors and two LEDs, and a button at the user's disposal. In addition, the set has breadboard with 170 holes.
Shield for Arduino Mega, allowing you to create your own systems (shields). The model is suitable for the latest versions of the family Arduino Mega Rev3. It has led out all the connectors and LEDs ,and reset button. In addition, set has breadboard with 170 holes.
Expander of pins on the basis of the MCP23017 system, it extends the capabilities of the Arduino or Raspberry Pi with additional 16 pins of I/O. It communicates via I2C interface. The supply voltage is 3.3 V or 5 V.
A shield which extends the capabilities of the Arduino. It allows you to connect various devices such as sensors, servos, buttons, potentiometers, relays, etc. It has led out the pins from Arduino board along with a couple to power 5 V and GND on the connectors goldpin with 2.54 mm pitch.
Shield for the Arduino Uno that allows you to create your own systems (shields). The model is suitable for the latest versions of the family of Arduino Uno Rev3. It has a place for two LEDs, ICSP connector and a 24-pin SMD chip.
Module for connecting a mobile power source for Arduino. It allows you to power the microcontroller from any battery voltage from 3 V to 4.2 V or solar panel voltage from 4.8 V to 6 V. It provides a stable 5 V and a maximum current of 600 mA.
The module is powered via battery and with the real-time clock RTC PCF8523 and a slot for microSD memory cards. FeatherWing extends the capabilities of the modules from Feather series by saving the actual data on the memory card.
The panel, consisting of two plates, will print out all the Arduino pins on the screw connection, to which you can connect cables with a screwdriver. In addition, the Board has analog and digital and power pins.
Shield for Arduino Uno Rev3 and derivatives, which allows you to create your own systems (shields). It has led out all the connectors and two LEDs, and a button at the user's disposal. In addition, the set has breadboard with 170 holes.
Shield for Arduino with 7 segment LED display 4 digits, 4 SMD LEDs, 3 independent buttons, buzzer, interfaces for sensors LM35 and DS18B20, interface IR receiver, potentiometer, and connector of the serial interface.
Shield for Arduino, which extends the I/O pis capabilities. It has i.a. led out each pin with a pair for power supply, possibility to turn on the voltage converter of 3.3 V, a separate connector for I2C, SPI interfaces, and a slot for XBee modules.
Expansion board with 16 GPIOs with I2C interface, which means that to make full use of all pins, it is sufficient to connect two wires to the microcontroller. SX1509 also has interfaces PWM. Board allows you to get more IO with fewer number of pins. It has the built-in motor of a keyboard that allows you to connect up to 64 buttons of matrix 8x8.
Shield for Arduino, which extends the capabillities of pins of the I/O. It has, i.a. led out each pin with a pair of power. It has 36 pins, including 14 digital pins, 6 analog pins and 16 pins of I2C. It facilitates the connection of sensors from Gravity series.